Midmark M11 Spezifikationen PDF herunterladen (Seite 24)

SECTION IV

MAINTENANCE / SERVICE

(4) Remove two screws (1, Figure 4-5) and base

inspection cover (2) from base (3).

B. Installation

(1) Install base inspection cover (2) on base (3) and

secure using two screws (1).

(2) Turn sterilizer upright.

(3) Refill condensing tank with distilled water.

4.7 Bellows Assembly Removal /

Installation

NOTE

Figure 4-6 shows old-style bellows. The procedure for

the new-style is the same.

A. Removal

(1) Remove back panel (Refer to para 4.5).

(2) Disconnect tube (1, Figure 4-6) from tee (2).

(3) Pull downward on bellows assembly (3) to

remove bellows assembly from condensing

tank (4).

(4) Loosen and remove tubes (1 and 5) from

bellows assembly (3).

MA2053-01

TUBE

HOLE

Figure 4-6. Bellows Assembly

Removal / Installation

B. Installation

(1) Connect tubes (1 and 5) to bellows assem-

bly (3).

(2) Position bellows assembly (3) and insert tube

(5) into tube hole of condensing tank (4).

(3) Connect tube (1) to tee (2).

(4) Install back panel (Refer to para 4.5).

MA2052-01

Figure 4-5. Base Inspection Cover

Removal / Installation

Return To Table Of Contents

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 133 134

Keine Kommentare

Midmark M11 Spezifikationen Seite 24