FILTERS: MIF038 or MIF062
Depending on the age of the machine, you will need to replace
either the sintered bronze style Chamber Filter (MIF038) or both
the mesh style Chamber Filter and Vent Filter (MIF062). See below
for instructions.
• Chamber Filter (sintered bronze style filter) – MIF038: If the
machine has only a Chamber Filter – Remove all trays and the rack
from the chamber. Clean the chamber, then remove the old
chamber filter.
Install new filter. Reinstall rack and trays.
• Chamber & Vent Filters (mesh style filter) – MIF062: If the
machine has both a Chamber and a Vent Filter – Remove all trays
and the rack from the chamber. Clean the chamber, then remove the
chamber filter. Install the new filter. You must also replace the Vent
Filter that serves as a filter for the steam trap/bellows and is locat-
ed in the vent line to the tee fitting. Reinstall rack and trays.
After replacing the parts, check the reservoir and clean if dirt or debris
are present. (Note: Debris is the #1 reason for Steam Trap/Bellows
failure.) • Refill reservoir with distilled water only. • Conduct a tem-
perature check using a Max Register Thermometer (RPI Part
#RPT113). • Conduct a pressure check to identify any leaks that may
need to be addressed.
3
DOOR GASKETS: MIG027 fits M9 and MIG028 fits M11
Remove the old door gasket. Clean the gasket groove in the door and
chamber face. For easy installation of the new gasket, use the “South-
East-West-North” method (i.e. begin installing the gasket at the bot-
tom of the door, then install the left and right sides and finish at the
top by squeezing in any of the excess, making sure that the gasket fits
flush).
DAM GASKETS: MIG035 fits M9 and MIG036 fits M11
Use CAUTION when removing or installing the dam gasket – the door
studs can be sharp. To install the door dam, align and place the dam
gasket on and over the door studs. The dam must lie flat against the
door (refer to the Installation Instructions included with the
MIG035/MIG036 dam gasket).
DOOR SPRING: MIS076
Remove the old spring. Reuse the screw to install the two new door
springs – one on top of the other. This will aid in the door opening.
R
E
P
L
A
C
E
M
E
N
T
P
A
R
T
S
I
N
D
U
S
T
R
I
E
S
,
I
N
C
.
S
T
E
R
I
L
I
Z
E
R
P
L
A
N
N
E
D
M
A
I
N
T
E
N
A
N
C
E
C
H
E
C
K
L
I
S
T
Sterilizer PM KIt (RPI Part #MIK072)
for parts to fit the M9 UltraClave
®
sterilizer
Sterilizer PM KIt (RPI Part #MIK080)
for parts to fit the M11 UltraClave
®
sterilizer
2.0 - PLANNED MAINTENANCE (PM) CHECK LIST
(134 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern